Fluke TL910 Electrical Test Lead Kit, CAT IV, CAT III, 3A

This multimeter leads set is designed to extend measurement capability in electronics, automation and electrical maintenance by providing fine-access probing with secure spring-loaded connections. It operates as a Compact electrical test lead kit for precision fault finding and component-level verification, delivering safe low-current measurements within common workshop and lab environments.

• 1m lead length for flexible reach and manoeuvrability
• 3A current rating for routine signal and low-power testing
• Spring-loaded pin connectors for positive contact on small pads
• CAT II 1000V safety rating for U-line and distribution-level work
• Includes multiple tip materials to suit varied test points

• Suitable for component-level diagnostics on control boards
• Ideal for commissioning sensors in automation systems
• Used with bench multimeters for electronics R&D tasks
• Can be used for maintenance of low-voltage distribution equipment
• Used for precision probing of hard-to-reach test points

The kit contains several sets of tips in both gold-plated spring-loaded pins and stainless-steel varieties to match plating and contact requirements.

Spring-loaded pins maintain consistent pressure at the contact interface, reducing intermittent readings and improving stability during small-signal measurements.

They are rated to CAT II at 1000V, which is appropriate for mains-connected equipment on single-phase distribution and similar installations.

Multiple tip sets are supplied with the leads so worn or application-specific tips can be swapped without replacing the entire assembly.