SEGGER 5.16.01 Flasher Portable In Circuit Programmer for use with Flash microcontrollers

Flasher Portable has been designed to fill the need for a portable, battery-operated production-grade Flash memory programmer used for in-field firmware updates. Initial setup/preparation for stand-alone mode operation is done via the J-Flash software. It supports storage of multiple configurations/image files, so one unit can be used for different targets.

• ARM 7/9/11
• ARM Cortex-A5/A7/A8/A9/A12/A15/A17
• ARM Cortex-M0/M0+/M1/M3/M4/M7
• ARM Cortex-R4/R5
• Freescale e200z0 (PowerPC)
• Renesas RX610/RX621/RX62G/RX62N/RX62T/RX630/RX631/RX63N/RX63T

• Stand-alone in-circuit-programmer
• Powered by 3 x AAA batteries or via USB connection
• Stores up to four configurations/data files
• Pushbutton selects between stored images/configurations
• 128MB memory for configuration and data file storage
• Supports internal and external Flash devices
• Data files can be updated via mass storage or via J-Flash
• Host interface: USB 2.0
• Target interfaces: 20-pin JTAG/SWD/FINE/SPD
• Programming speed typically between 30KB/sec and 1MB/sec
• Max programming speed depends on target hardware and max programming speed of the Flash memory
• Authorized Flashing limits number of programming cycles and protects against non-authorized access
• Dimensions: 130 x 65 x 25mm
• Free software updates, 2 years of support

20-pin 0.1in target ribbon cable, USB cable, 3 x AAA batteries