NXP SC18IS602BIPW,112, SPI to I2C Bridge, I2C, SPI, 1-TX 1-RX, 1.8MBps, 16-Pin TSSOP

  • RS Stock No. 865-2202
  • Mfr. Part No. SC18IS602BIPW,112
  • Manufacturer NXP
Product overview and Technical data sheets
Legislation and Compliance
RoHS Certificate of Compliance
Product Details

Serial I/O Peripherals, NXP

Note

NXP is a trademark of NXP B.V.

Specifications
Attribute Value
Number of Transmitters 1
Number of Receivers 1
Data Rate 1.8Mbps
Mounting Type Surface Mount
Package Type TSSOP
Pin Count 16
Transmitter Signal Type Single Ended
Receiver Signal Type Single Ended
Interface Standards I2C, SPI
Power Supply Type Single
Typical Single Supply Voltage 2.4 → 3.6 V
Maximum Operating Temperature +85 °C
Height 0.95mm
Minimum Operating Temperature -40 °C
Width 4.5mm
Length 5.1mm
Dimensions 5.1 x 4.5 x 0.95mm
Discontinued product
Related Products
Linear Technology offer a range of Hot Swap ...
Description:
Linear Technology offer a range of Hot Swap controllers providing circuit protection by limiting inrush current as well as fault isolation. They allow electronic circuit boards and cards to be inserted into live system backplanes. Hot Swap controller will sense, ...
Linear Technology offer a range of Hot Swap ...
Description:
Linear Technology offer a range of Hot Swap controllers providing circuit protection by limiting inrush current as well as fault isolation. They allow electronic circuit boards and cards to be inserted into live system backplanes. Hot Swap controller will sense, ...
Wide +9V to +72V OperationRequires No External Sense ...
Description:
Wide +9V to +72V OperationRequires No External Sense ResistorDrives External p-Channel MOSFETLimits Inrush CurrentCircuit-Breaker FunctionLess than 2mA Quiescent CurrentON/Active-Low OFF Input Permits Load Power-Supply Control and SequencingAdjustable Undervoltage LockoutPower-Good Output with +72V RatingLatching ...
Linear Technology offer a range of Hot Swap ...
Description:
Linear Technology offer a range of Hot Swap controllers providing circuit protection by limiting inrush current as well as fault isolation. They allow electronic circuit boards and cards to be inserted into live system backplanes. Hot Swap controller will sense, ...